ZAR87 Welldeck

Features

 

  • Driving consolle in VTR with anatomic 2 seater front seat,multifunctional anatomic driver’s couch for 3 seaters with 2 driving position (sitting up or down), steering gear and stainless steel handrail, hydraulic steering gear, windscreen, peak under the driver’s couch; separated toilet; predisposition for double bed with peaks; n. 3 portholes

  • 3 rows that can seat 10 persons forward running

  • front sun bathing bed convertible into a double bed (cm 190 x 230) with extensions as an optional

  • 195 x 2000 back sunbathing bed with extensions as an optional

  • kitchen area under the driver’s couch equipped with: sink, mincing board, double gas ring and refrigerator special compartment predisposition • wide stem dinette with a table as an optional

  • close cell cushions

  • padded interior sidewalls and bow

  • wide rear peak

  • wide front peak

  • back peak with the mooring accessories

  • 5 side peaks in the sides

  • 3 gas springs for afterpeak and forepeak covers

  • anchor winch nose with stainless steel bow, 9 kg. stainless steel anchor

  • 1 tank of about 550 lt complying with CE regulation

  • bilge pump

  • 7 Stainless steel handles

  • 2 stainless steel grab rods in prow

  • 4 bollards

  • perimetric double millpond

  • stainless steel ladder

  • n. 2 dashboards in VTR

  • n. 4 rubber handling handles

  • n. 3 stainless steel eyebolts for hangers

  • repairs kit, inflating device, a pair of paddles

 

Technical Data

 

  • Static self emptying

  • Length m 8,70

  • Width m 3,20

  • Internal walking length m 8,70

  • Internal walking width m 2,25

  • Intertubular width m 2,00

  • Tubular diameter cm 60

  • Watertight compartments n. 6

  • Seating capacity n. 12/14

  • Net dinghy weight kg 2,100 (with standard equipment, without liquids and motor) ± 10% variable datum

  • Maximum power applicable KW 442 HP600

  • Minimum power applicable (minimum performance)HP 300

  • Power recommended (average performance) HP300

  • Engine shaft lenght

  • n. 1 engine XXL

  • n. 2 engines XL

  • Max. weight installable motors kg 600

  • CE certification with “B” design category (A+a form)

Optional Equipment

 

  • Stainless steel roll-bar with fibreglass bases

  • Roll-bar installation with running lights, anchorage lights, horn and wiring • Beacon ready installed on roll-bar/console

  • Prow sunbed extension

  • Stern sunbed extension

  • Total sheet for night and travelling

  • Console cover

  • Seat cover Electric panel Shower (for stern external wash basin and bathroom in console) complete with autoclave, water tank, outdoor embarkation, discharge pump and installation

  • Complete dingy heuling belt kit for launch/accommodation Anchor windlass installed with motor, cable, chain and double controls (in console and anchor housing)

  • Electrical actuator for stern peak lifting

  • Electric sea WC with installed direct discharge

  • Electric sea WC with installed black water tank

  • Full set of cabin cushions + 6 cushions in different colours

  • Wooden floor + step cover + shower for cabin and bathroom

  • Table inside the cabin

  • Chartwork light inside the cabin

  • Service light inside the cabin

  • Electric refrigerator (12/24V)

  • Two burner cooker

  • Flexi-teak for cockpit

  • Flexi-teak installation

  • External night canopy
     

 

Copyright © 2004-2020 La Marca Marine. All Rights Reserved. a Division of La Marca International Pte Ltd (Reg. No. 200416275C)