ZAR87 Welldeck

ZAR87 Welldeck 1
ZAR87 Welldeck 2
ZAR87 Welldeck 3
ZAR87 Welldeck 4
ZAR87 Welldeck 5
ZAR87 Welldeck 6
ZAR87 Welldeck 7
ZAR87 Welldeck 8
previous arrow
next arrow

ZAR87 Welldeck

Features

  • Driving consolle in VTR with anatomic 2 seater front seat,multifunctional anatomic driver’s couch for 3 seaters with 2 driving position (sitting up or down), steering gear and stainless steel handrail, hydraulic steering gear, windscreen, peak under the driver’s couch; separated toilet; predisposition for double bed with peaks; n. 3 portholes
  • 3 rows that can seat 10 persons forward running
  • front sun bathing bed convertible into a double bed (cm 190 x 230) with extensions as an optional
  • 195 x 2000 back sunbathing bed with extensions as an optional
  • kitchen area under the driver’s couch equipped with: sink, mincing board, double gas ring and refrigerator special compartment predisposition • wide stem dinette with a table as an optional
  • close cell cushions
  • padded interior sidewalls and bow
  • wide rear peak
  • wide front peak
  • back peak with the mooring accessories
  • 5 side peaks in the sides
  • 3 gas springs for afterpeak and forepeak covers
  • anchor winch nose with stainless steel bow, 9 kg. stainless steel anchor
  • 1 tank of about 550 lt complying with CE regulation
  • bilge pump
  • 7 Stainless steel handles
  • 2 stainless steel grab rods in prow
  • 4 bollards
  • perimetric double millpond
  • stainless steel ladder
  • 2 dashboards in VTR
  • 4 rubber handling handles
  • 3 stainless steel eyebolts for hangers
  • repairs kit, inflating device, a pair of paddles

Technical Data

  • Static self emptying
  • Length m 8,70
  • Width m 3,20
  • Internal walking length m 8,70
  • Internal walking width m 2,25
  • Intertubular width m 2,00
  • Tubular diameter cm 60
  • Watertight compartments n. 6
  • Seating capacity n. 12/14
  • Net dinghy weight kg 2,100 (with standard equipment, without liquids and motor) ± 10% variable datum
  • Maximum power applicable KW 442 HP600
  • Minimum power applicable (minimum performance)HP 300
  • Power recommended (average performance) HP300
  • Engine shaft lenght
  • 1 engine XXL
  • 2 engines XL
  • weight installable motors kg 600
  • CE certification with “B” design category (A+a form)

Optional Equipment

  • Stainless steel roll-bar with fibreglass bases
  • Roll-bar installation with running lights, anchorage lights, horn and wiring • Beacon ready installed on roll-bar/console
  • Prow sunbed extension
  • Stern sunbed extension
  • Total sheet for night and travelling
  • Console cover
  • Seat cover Electric panel Shower (for stern external wash basin and bathroom in console) complete with autoclave, water tank, outdoor embarkation, discharge pump and installation
  • Complete dingy heuling belt kit for launch/accommodation Anchor windlass installed with motor, cable, chain and double controls (in console and anchor housing)
  • Electrical actuator for stern peak lifting
  • Electric sea WC with installed direct discharge
  • Electric sea WC with installed black water tank
  • Full set of cabin cushions + 6 cushions in different colours
  • Wooden floor + step cover + shower for cabin and bathroom
  • Table inside the cabin
  • Chartwork light inside the cabin
  • Service light inside the cabin
  • Electric refrigerator (12/24V)
  • Two burner cooker
  • Flexi-teak for cockpit
  • Flexi-teak installation
  • External night canopy
Posted in ZAR Formenti RIBS.